Epoxy Flooring in Maryville, TN

Maryville is a separate city in Blount County, about 15 miles south of Knoxville, sitting in the foothills on the way toward the Great Smoky Mountains. It is a growing community — a historic downtown core surrounded by rapidly expanding subdivisions — and it sits right next to Alcoa.

We connect Maryville homeowners with licensed installers for garage floor coatings, basement floors, and workshop coatings across Blount County. The foothills setting gives Maryville projects one characteristic the flatter parts of Knox County do not have.

Garage floor coatings in Maryville

A garage floor coating is the most-requested project in Maryville, and the work mirrors what we do across the Knoxville metro: a diamond-ground slab, crack and joint repair, and an epoxy, flake, or polyaspartic system sealed with a wear topcoat. A typical Maryville two-car garage runs roughly $2,300 to $4,500 in a flake epoxy system, with polyaspartic and decorative metallic upgrades available.

What varies in Maryville is the slab underneath. A garage floor coating on a new subdivision build needs only standard preparation; the same coating on an older home near downtown Maryville often needs crack repair first. Either way, the quote is based on an on-site look at your concrete — never sight-unseen pricing.

Foothills terrain means more basements

A lot of Maryville and Blount County homes sit on sloped lots. That produces walkout basements, daylight basements, and basement-level garages far more often than you see in flatter West Knoxville. Basement floor coatings are a genuine segment of the work here — finished basement living space, basement gyms, and lower-level garages.

Hillside slabs make moisture management the central issue. A basement or below-grade slab on a slope can take on vapor from the uphill side, and a coating applied without testing will lift. Every Maryville basement project should start with a moisture test; it is the single most important step on a foothills slab.

Old downtown homes and new subdivisions

Maryville's housing splits into two groups. The older homes near downtown Maryville sit on mid-century concrete and need the same careful prep — crack repair, joint work — as Knoxville's older neighborhoods. The new subdivisions spreading around the city have modern, sound slabs that need only standard grinding. A quote depends on which Maryville you are in, which is why an on-site look at the concrete is the only honest way to price the job.

Floor coatings we install in Maryville

Every system we offer across East Tennessee is available in Maryville. Each links through to a full breakdown of the system, finishes, and pricing:

Not sure what a project runs? The Knoxville epoxy flooring cost guide breaks pricing down by system and by garage size.

Maryville questions

Do you serve Maryville and the rest of Blount County?

Yes. Maryville, Alcoa, Rockford, Friendsville, and the surrounding Blount County area are all within our service area. Mention your part of the county when you call so the installer can plan the visit.

Can you coat a basement floor in a Maryville hillside home?

Yes, and basement floors are a common request here. The one firm requirement is a moisture test before any coating goes down — foothills and below-grade slabs can carry vapor from the uphill side, and testing first is what keeps the floor from lifting later.

How much does a Maryville garage floor coating cost?

A standard two-car Maryville garage runs roughly $2,300 to $4,500 in a flake epoxy system. Older homes near downtown may need extra prep; newer subdivision slabs usually do not. An on-site measurement gives you an exact figure.

Get a free quote

Tell us about your floor and a licensed East Tennessee installer will measure the space, inspect the concrete, and put a full written quote in front of you — no sight-unseen pricing.

Call (865) 459-3144 or see every community we cover on our service area page.

Last updated: May 20, 2026